Wagler Billet 7.3 connecting rods Feature an improved H-beam design Use military-spec, aircraft-quality, chromoly steel, which is said to be similar to 300M These rods are triple-tempered, surface-peened, cryogenic treated, and balanced plus or...

DSHPOPADR 1996-2003 7.3L ADRENALINE HIGH PRESSURE OIL PUMP VJ365

Head gasket failure is one of the most common problems with 94-03 7.3L Powerstrokes. Installing ARP headstuds is a must, especially if you are running a chip or programmer that modifies your boost. It is for good reason that virtually every top...

Smith Brothers push rods are a direct replacement, 4130 material, stock dimension push rods. Increased strength, stop flex, and reduce the chances of a bent push rod. (set of 16)

The Ford F81Z-9C968-AB Fuel Injection Pressure Regulator is an OEM Ford replacement for your 94-03 Ford 7.3L Powerstroke. Without edge filter.

As the 7.3L trucks get older, oil pan leaks get more and more common. One of the most frequent sources of oil pan leaks is from the factory dipstick adapter in the side of the oil pan.

The kit includes the two boots that connect the intercooler piping to the intercooler on both sides of the radiator. It includes four T-bolt spring clamps. The spring bolt clamps are 300 series stainless steel with zinc coated bolts with a 300lb clamping strength. Recommended torque is 60 in/lbs.

The kit includes the two boots that connect the intake manifold to the cylinder heads on the Early 1999 Powerstroke. It includes four worm drive clamps for the boots. The spring bolt clamps are not to be used in this application as they will damage the intakes.

This kit includes the two boots that connect the intake manifold piping ("Spider") to the intake plenums on 1999.5-2003 7.3L PSD trucks. Also included are four worm gear drive clamps.